ST Aero unveiled at the 2008 Singapore Airshow a number of new
UAVs, including the vertical take-off and landing Fantail 5000,
the Skyblade III electrically powered hand-launched mini-UAV,
and Skyblade IV tactical small UAV capable to fly missions for
up to 12 hours.
ST Aero displayed here a number of UAVs, including the vertical
take-off and landing "Fantail 5000", a 6.5 kg variant
of the Fantail family of VTOL UAVs capable of operating at a range
of 8 km and a maximum speed of 90 knots. This UAV can hover continuously
for about 30 minutes. It represents a significant growth compared
to the earlier Fantail 3000 version, which was quite limited by
weather and wind conditions.
Another UAV developed in Singapore is ST Aero's Skyblade III,
a five kg vehicle following the general outline of the Elbit System's
Skylark I design (although Elbit denied any part in the Singaporean
program). Launched by hand and supported by two soldiers, Skyblade
III can operate at latitudes between 300 and 1,500 ft. All avionics,
sensors, communications and the power source are contained in
a large pod suspended below the tube-shaped fuselage.
Another member of ST Aero's Skyblade family is the Skyblade IV,
a V tail shaped 2 meter long tactical UAV with a wing span of
3.5 meters, this vehicle weighs 50kg on takeoff and carries up
to 12 kg of usable payload. It can climb up to 15,000 ft flying
a mission of 12 hours. The range of 100 km is limited mostly by
line-of-sight communications. Skyblade IV will be equipped with
an EO/IR payload. This UAV is expected to fly in 2009.
The Singapore Air Force is the lead operator of UAVs in the island
city state. The air forces' UAV command operates three squadrons,
flying IAI/Malat Searcher, Heron and Elbit Systems/Hermes 450.
The Singapore Army is expected to be the lead service for the
smaller UAVs. Singapore is planning to field mini-UAVs as part
of its land forces modernization but has not yet decided on which
system to procure.
Following
the induction of Hermes 450 into service with the Singapore Air
Force; UAV wing, Elbit Systems introduced improved versions of
its Hermes family, including Hermes 900, Hermes 450B and a modified
version of the Hermes 450 fitted with a new engine, contributing
to much improved payload capacity. The Hermes 900 was displayed
in a full scale, 15 m' wing span model representing the latest
addition to the Hermes family of UAVs. The prototype is expected
to fly this year. Haim Kellerman, general manager of Elbit Systems
UAV activities, told Defense Update that the new Hermes will fully
integrate with current Hermes 450 systems, offering users to extend
their capabilities and assume more challenging missions, with
longer endurance, and heavier payloads (the '900 will have a gross
takeoff weight of 970 kg, carrying up to 300 kg of payloads).
It is designed for all-weather operations it will use fully redundant,
fault-tolerant avionics, and will be powered by fully-certified
Rotax engine. The aircraft will be equipped with reconnaissance
and surveillance payloads such as EO and SAR, communications intelligence
or electronic signal intelligence collection systems etc. Over
short and medium range missions, the system maintains secure,
redundant line-of-sight (LOS) datalink as well as redundant satellite
communications when employed on long range missions, beyond line
of sight (BLOS).
The new Hermes 900 will be equipped with advanced features including
built-in autonomous emergency procedures, Air Traffic Control
(ATC) radio, radio relay and IFF transponder, effectively integrating
the unmanned aircraft for flight in ATC controlled segregated
airspace while safely sharing flight corridors with conventional
air traffic. Auto-Takeoff and Landing (IATOL) system, effectively
integrating the unmanned aircraft with certified for such missions
enabling auto-landing even in alternate non-instrumented runways.
The aircraft will be controlled by the Universal Ground Control
System (UGCS), already used with Hermes family systems.
Hermes 450, the workhorse of the Israel Air Force UAV units was
proven as an instrumental asset during the War in Lebanon in 2006.
A new Hermes 450 unit delivered to the British Army, supported
by Thales UK was urgently dispatched to improve reconnaissance
and surveillance for the coalition forces in Afghanistan and Iraq.
In total, in the recent years the Hermes 450 fleet surpassed 60,000
operational hours.
At
the Singapore Airshow Elbit Systems displayed two of the Hermes
450 models – the Watchkeeper platform, also known as Hermes
450B and the evolved version of the Hermes 450 recently , equipped
with a new R902 utilizing a wide rotary (wankel) engine block
developed by Elbit Systems. According to Kellerman, the new engines
can be retrofitted to the Hermes 450 aircraft in service. The
engine has fuel injection system which further improved fuel consumption,
an integral electrical starter, automatic takeoff and landing
and remotely controlled brakes integrated in the landing gear,
improving self sufficiency at forward operation bases. The introduction
of the new engine improves power/weight ration of the platform,
increasing gross takeoff by 17% (470 kg to 550 kg), providing
for more fuel for extended mission endurance (adding about 10
hours), without relying on external fuel.
Development of the Watchkeeper is at the final phase. Addressing
the UK requirements, this robust platform was designed with dual-payload
system capability as a baseline. It is also designed to operate
in cold, rough weather conditions, equipped with de-icing system.
Watchkeeper is designed to comply with future visual and instrument
flying rules in segregated airspace and through civilian air traffic
corridors, and Elbit expects it will be fully certified for such
missions.
The following articles are included
in this issue: